News

When using internal diaphragm, make sure the corners of it are cut. On larger RHS use a stiffener with a central hole as well as cut corners. NEVER arrange a plate that blocks the entire cross section. It may be dangerous during hot dip galvanizing. (One may happen to be unpleasantly surprised when receiving an invoice if the entire section has filled with zinc which cannot escape!)

Following the innovations, we have renovated the factory equipment and installed a larger zinc bath, which allows coating with zinc even larger steel structures, optimizing the processes and offering the clients more cost-effective and faster solutions. The dimensions of the bath are 9000 x 3000 x 1600 mm. This is a case when the size really matters!